Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Change Engine Oil on a Derbi GPR 125

Model: Derbi Gpr 125
Part: Engine oil

Video tutorial

How to change the engine oil on a Derbi GPR 125? Follow this guide to proceed with the replacement. Position the bike on a central stand; remove the plastic filler cap and using a spanner, unscrew the bolt of the oil sump (drain the fluid into a disposal container).

Unscrew the oil filter if you need to replace it (fit the new oil filter). Finally, top up with new fluid in the engine and close with the plastic cap. Test the correct functioning of the bike.

Use oil recommended by the manufacturer.


Updated on 9 March 2026 by ScegliAuto


Related tutorials

How to perform a service (oil change and oil filter) on the Derbi GPR 125
How to perform a service (oil change and oil filter) on the Derbi GPR 125
Gpr 125 Discover the procedure for replacing the engine oil and oil filter while performing the regular service maintenance on the Derbi GPR 125 motorcycle. …
How to Replace the Exhaust on the Derbi GPR 125?
How to Replace the Exhaust on the Derbi GPR 125?
Gpr 125 You can replace the exhaust on the Derbi GPR 125 by loosening the screws that secure the exhaust end can to its housing, located near the rear swinga…
How do you disassemble the engine of the Derbi GPR 125?
How do you disassemble the engine of the Derbi GPR 125?
Gpr 125 To disassemble the engine of the Derbi GPR 125, you will need to loosen the screws that fix the engine block to its housing in the center of the fram…

How to Change the Engine Oil on a BMW R1200T?

To change the engine oil on a BMW R1200T, follow these steps. Ensure the bike is on a level surface and the engine is warm but not too hot. Remove the oil filler cap and the oil drain plug, usually located on the underside of the engine. Position a collection container under the drain plug and unscrew it to fully drain the used oil. Once drained, remove and replace the oil filter, ensuring to clean the mounting surface thoroughly. Install the new filter and screw the oil drain plug back in. Fill the engine with new oil through the filler cap until reaching the recommended amount, checking the level with the dipstick if necessary. Secure both caps tightly. Start the engine for a few minutes to circulate the new oil, then turn it off, and the replacement is complete.

Watch the video!


by ScegliAuto

More videos