Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
  1. Motorcycles
    2. :
  2. Derbi
    3. : Gpr 80
You can change the oil in the Derbi GPR 80 gearbox by unscrewing the drain plug of the transmission casing, which is located at the lower rear part of it: once the plug is unscrewed, you can let all the used oil flow into a suitably placed container until it has completely drained out. At this point, you can insert the necessary amount of oil through the same breather: you will need to push it into the casing using a pump to completely fill the lubrication circuit.

Posted on 26 August 2026 by ScegliAuto

Video tutorial

Related tutorials

How to perform a service (oil change and oil filter) on the Derbi GPR 125
How to perform a service (oil change and oil filter) on the Derbi GPR 125
Gpr 125 Discover the procedure for replacing the engine oil and oil filter while performing the regular service maintenance on the Derbi GPR 125 motorcycle. …
How to Change Engine Oil on a Derbi GPR 125
How to Change Engine Oil on a Derbi GPR 125
Gpr 125 How to change the engine oil on a Derbi GPR 125? Follow this guide to proceed with the replacement. Position the bike on a central stand; remove the …
How do you bleed the brakes on the Derbi GPR 125?
How do you bleed the brakes on the Derbi GPR 125?
Gpr 125 To perform the brake bleeding on the Derbi GPR 125, you need to loosen the small drain valve located at each of the screws to let the oil out: you wi…

How to Check the Coolant Level in a Yamaha Xmax

In the following video, you will learn how to check the coolant level in a 2008 Yamaha Xmax. First, position the motorcycle on a stable surface by raising the stand. Next, lift the cover located at the top of the motorcycle to access the coolant drain bolt. To top up the coolant, unscrew the cap as shown in the video and add the fluid until it reaches the maximum level, indicated as Max. Once finished, close the valve and refit the cover. At this point, start the engine and let it run at idle for a few minutes to eliminate any air bubbles that may have formed inside.

Watch the video!


by ScegliAuto

More videos