Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Oil and Oil Filter Change on Derbi Rambla 125

Model: Derbi Rambla 125
Part: Engine oil

Video tutorial

Position a container under the engine compartment and use a 24 mm extended socket to unscrew the drain bolt clearly shown in the video. While collecting the oil, unscrew the oil filter located next to the drain bolt using a special filter wrench.

Insert the new filter after lubricating its O-ring, screw it in tightly, also screw in the drain bolt, and refill with new oil through the upper hole. Remember that before performing an oil change, it is advisable to run the engine for a few minutes to warm up the circulating oil (making it less viscous) and facilitate its subsequent removal.


Updated on 15 April 2026 by ScegliAuto


Related tutorials

How do you replace the exhaust pipe of the Derbi Rambla 125?
Rambla 125 In order to replace the exhaust of the Derbi Rambla 125, you need to loosen the screws that fix it to the appropriate supports on the right side of t…
How do you replace the exhaust pipe of the Derbi Rambla 125?
Rambla 125 To replace the exhaust pipe of the Derbi Rambla 125, you need to loosen the screws that fix the exhaust terminal to its housing, on the right side of…
How to Replace the Rear Wheel of a Derbi Rambla 125?
How to Replace the Rear Wheel of a Derbi Rambla 125?
Rambla 125 To replace the rear wheel of a Derbi Rambla 125, loosen the bolts securing the exhaust at the rear of the bike. Once these bolts are loosened, you ca…
ScegliAuto offers an extensive international collection of automotive tutorials available in 12 languages. Each guide combines instructional videos with original explanations written by experienced human editors, along with information about the car models covered.

How to Reset the Engine Light on a Yamaha Ray RZ?

To reset the engine light on a Yamaha Ray RZ, connect a diagnostic tool to the vehicle's OBD port. The OBD port is located just above the battery housing, accessible by removing the panel in the centre of the footwell. Once this panel is removed, connect the scanner and select the car model and its corresponding version. After connecting the scanner and following the tutorial steps, you will notice that the light has been reset.

Watch the video!


by ScegliAuto

More videos