Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
Below are the instructions to adjust the clutch cable on a Royal Enfield Classic 350 motorcycle, as well as on the Bullet. First, place your motorcycle on the centre stand and begin adjusting the adjuster located on the transmission cover; pull until it is taut, using a spanner. At this point, make the final adjustment using the screw near the clutch lever; ensure that the lever returns perfectly when released. Start the engine and check the operation of the clutch.

Updated on 10 September 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Clutch Cable on the Royal Enfield Classic 350
Classic 350 In this guide, you will learn how to remove and replace the clutch cable on the Royal Enfield Classic 350 motorcycle. First, place your bike on the c…
How do you replace the clutch of the Royal Enfield Classic 350?
How do you replace the clutch of the Royal Enfield Classic 350?
Classic 350 The clutch replacement of the Royal Enfield Classic 350 can be carried out by loosening the screws that secure the transmission case, at the central …
How do you replace the clutch of the Royal Enfield Classic 350?
How do you replace the clutch of the Royal Enfield Classic 350?
Classic 350 The clutch of the Royal Enfield Classic 350 can be replaced by loosening the screws that fix the clutch cover on the right side, in the central lower…

How to Remove the Rear Wheel on the BMW G650 GS?

In this tutorial, you will see how to remove the rear wheel on the BMW G650 GS, a very simple operation. First, lift the motorcycle from the central area using a stand or a jack, then undo the right nut with a 24 mm socket and the left one with a 19 mm spanner. Once done, using a Torx T40 key, unscrew the two chain tensioner bolts exactly half a turn each, until you loosen the tension. Finally, push the wheel towards the inside of the motorcycle, remove the chain from the sprocket, and extract the inner pin using a hammer.

Watch the video!


by ScegliAuto

More videos