Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Fiat
    3. :
  3. Stilo
    4. : How to remove steering wheel on Fiat Stilo

Fiat Stilo - Video tutorial

Model: Fiat Stilo MK 1 - Years 2001-2010
Part: Steering wheel
Operation: How to remove steering wheel on Fiat Stilo

Removing the steering wheel airbag on a Fiat Stilo? Let's see the disassembly. Unscrew the tightening screws on the rear of the steering wheel with a screwdriver (the airbag is in front). Once the airbag (driver's side) has been released, disconnect the power supply terminals and extract it from the steering wheel. To reassemble the airbag we connect the power supply terminals, then, we press the same on the steering wheel with our hands and at the same time we tighten the rear screws. We disconnect the power supply terminals if we need to cut some wires or replace connection terminals. We connect everything at the end of the assembly.


Posted on 3 December 2023 by ScegliAuto



Disassembly steering wheel on Fiat Stilo
Fiat Stilo (2001-2010 / MK 1) Let's see in this video tutorial how to remove the steering wheel, together with the airbag, on a Fiat Stilo, in simple steps. First we get inside th
Disassembly of the steering wheel airbag on Fiat Stilo
Fiat Stilo (2001-2010 / MK 1) In today's video tutorial we will see how to remove the steering wheel airbag on a Fiat Stilo, following the instructions below. First we get inside
Disassembly of the Fiat Stilo instrument panel
Fiat Stilo (2001-2010 / MK 1) In today's video tutorial we will see how to remove the instrument panel of a Fiat Stilo, in simple steps. First we get inside the car and we go to r

    Frequently Asked Questions

    • Stilo 2001-2010 - Where is the 2006 Fiat Stilo 1400 power steering motor relay located? Read Answer

Fiat Ducato 2.8 JTD gearbox oil replacement

Let's see in this guide the main steps to be able to change the transmission oil of the second series Fiat Ducato, with 2.8 JTD engine. First of all we lift the car and go to locate the gear oil vent bolt, which we find near the transmission; we use a hex wrench to unscrew it, letting it drain the old oil in a container for about ten minutes. At this point we open the bonnet and remove the air intake sleeve, so as to be able to access the gearbox oil filling hole; then we fill up to the maximum level!

Watch the video!


by ScegliAuto

More videos