Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Remove the Rear Wiper Motor on Fiat Punto

Model: Fiat Punto MK 1, 176 - Years 1993-1999
Part: Power window motor

In this video tutorial, you will learn how to remove the rear wiper motor on a first-generation Fiat Punto by following the instructions below. First, remove the rear wiper; then open the boot and remove its inner panel by unscrewing the fixing screw. Now access the wiper motor; to remove it, simply unscrew its fixing screws and disconnect its electrical connector, as shown in the video. Now replace it with the new part, following the video tutorial to the end!

Updated on 6 April 2026 by ScegliAuto

This video is currently unavailable

Related tutorials

Removing the Wiper Motor from a Fiat Punto
Removing the Wiper Motor from a Fiat Punto
Fiat Punto (1999-2011 / MK 2, 188) In this video guide, you will learn how to remove the wiper motor from a second-generation Fiat Punto. First, remove the wipers by pressing the butto…
Replacing the Wiper Motor on Fiat Punto
Replacing the Wiper Motor on Fiat Punto
Fiat Punto (1999-2011 / MK 2, 188) In this guide, learn how to replace the wiper motor on a Fiat Punto. Pull the plastic lever located at the bottom left of the dashboard, lift the eng…
How to Replace the Starter Motor on a Fiat Punto 1.2
How to Replace the Starter Motor on a Fiat Punto 1.2
Fiat Punto (1999-2011 / MK 2, 188) Today, discover the guide and steps to remove and replace the starter motor on a Fiat Punto 1.2. First, open the bonnet of the vehicle and begin by r…

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos