Do it yourself
Frequently asked questions about cars and motorcycles
  1. Car
  2. :
  3. Fiat
  4. :
  5. Punto
  6. : How to remove the headlight on Fiat Punto 2

Fiat Punto - Video tutorial

Model: Fiat Punto 188, MK 2 - Years 1999-2011
Part: Headlight
Operation: How to remove the headlight on Fiat Punto 2

In this video tutorial we will see how to remove the headlight on a second series Fiat Punto, following the instructions below. First of all we open the bonnet of our car and we go to remove the front mask; then unscrew the upper and side fixing screws of the light and then disconnect the electrical connector of the bulbs, as shown in the video. At this point we will be able, eventually, to replace all the lamps or those that are not working; carry out the same operation for the other light and apply the reverse procedure for reassembly!


Posted on 17 January 2024 by ScegliAuto



How to replace the headlight bulb of the Fiat Punto?
Fiat Punto (2005-2018 / Punto EVO, Grandepunto , MK 3, 199) In order to replace the Fiat Punto headlight bulb, access the rear part of the car headlight by opening the hood and accessing the engine compartment
How to disassemble the headlight of the Fiat Punto?
Fiat Punto (2005-2018 / Punto EVO, Grandepunto , MK 3, 199) Removing the headlight from the Fiat Punto is very simple, let's see how to proceed in this tutorial valid for the second and third series Punto. For
How to change the headlight bulbs of a Fiat Punto
Fiat Punto (2005-2018 / Punto EVO, Grandepunto , MK 3, 199) Let's see how to change the bulbs located in the headlight of a Fiat Punto: open the front hood by pulling the lever located at the bottom right of t

    Frequently Asked Questions

    • Punto 2005-2018 - Where are the sidelights on Fiat Grande Punto? Read Answer
    • Punto 1999-2011 - How to remove the headlight on Fiat Punto mk2? Read Answer
    • Punto 2005-2018 - How much do the headlights of a used Fiat Punto cost? Read Answer

Fiat Ducato 2.8 JTD gearbox oil replacement

Let's see in this guide the main steps to be able to change the transmission oil of the second series Fiat Ducato, with 2.8 JTD engine. First of all we lift the car and go to locate the gear oil vent bolt, which we find near the transmission; we use a hex wrench to unscrew it, letting it drain the old oil in a container for about ten minutes. At this point we open the bonnet and remove the air intake sleeve, so as to be able to access the gearbox oil filling hole; then we fill up to the maximum level!

Watch the video!


by ScegliAuto

More videos