Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Remove the Radio in a Fiat Linea?

Model: Fiat Linea MK 1 - Years: 2007, 2008, 2009, 2010, 2011, 2012, 2013, 2014, 2015, 2016, 2017, 2018
Part: Car stereo

Video tutorial

As we can see in this tutorial, removing the radio in a Fiat Linea is a very simple and quick operation. To do this, you will need the appropriate keys available online, but if you don't have them, you can use equivalent tools.

First, ensure that the vehicle is off, then insert both keys fully into the 4 holes located near the two side knobs. At this point, unlock the internal clips, grasp the entire unit, and pull it out of the housing.

Finally, disconnect the rear connectors and install the replacement by following the reverse procedure.


Updated on 6 August 2026 by ScegliAuto


Related tutorials

Replacement of the starter motor for the Fiat Linea 1.3 MultiJet
Replacement of the starter motor for the Fiat Linea 1.3 MultiJet
Fiat Linea (2007-2018 / MK 1) In this guide, we will see the main instructions on how to disassemble and replace the starter motor of the Fiat Linea 1.3 MultiJet. First, let's ope…
How to locate the fuses on a Fiat Linea
How to locate the fuses on a Fiat Linea
Fiat Linea (2007-2018 / MK 1) To locate the fuses on a Fiat Linea, first check the cabin. Open the driver’s side door and locate the side panel of the dashboard: gently pry off th…
How to replace the gear knob of the Fiat Linea
How to replace the gear knob of the Fiat Linea
Fiat Linea (2007-2018 / MK 1) Replacing the gear knob of your Fiat Linea is undoubtedly one of the simplest operations that you can also perform independently and without any part…

How to reset the Service light on a 2019 Jeep Renegade?

The Service light, depicted as a yellow spanner, illuminates as scheduled to remind the driver that it is time for scheduled maintenance. This means that the set mileage has been reached, or the expected time has passed. The procedure involves turning on the instrument cluster, pressing the accelerator three times, and then turning off the ignition. After this, keep the brake pressed, turn the ignition back on, and then turn it off again. Upon the next ignition, you will notice that the light has been reset.

Watch the video!


by ScegliAuto

More videos