Installation of Aftermarket Armrest

To facilitate the installation, move the passenger seat forward by tilting the backrest.
Using a 7 mm socket spanner, remove the screws located on both sides of the centre tunnel at the rear. Then lift the centre tunnel to expose the support brackets of the removed screws, remove both anchoring clips of the screws and reposition the tunnel.
Extract the rubber cover from the storage compartment (or bottle holder) located at the rear of the tunnel and detach the upper part of the tunnel from the lower part by simply pulling it upwards and disconnect the cable located just beneath the tunnel cover.
Insert the supplied drilling template into the bottom of the bottle holder and mark with a punch the 4 points where the holes will be made, then drill the holes using a 10 mm drill bit; remove the template and plastic shavings.
Screw the two spacers provided onto the captive nuts located at the rear of the tunnel and tighten them with a 10 mm spanner.
Attach the support bracket inside the lower part of the tunnel and secure it laterally with the two supplied pins and washers (in place of the two side screws previously removed) and to the newly installed spacer.
Reattach the upper part of the tunnel ensuring the alignment of the drilled holes with those of the bracket.
Using a 4 mm Allen key, remove the fixing pin of the armrest from the support and slide out the armrest itself; unscrew the fixing screw of the plastic cover of the support bracket and slide it off.
Then insert the armrest support bracket inside the tunnel and secure it with the 4 supplied pins; reapply and secure the plastic cover.
Finally, insert the armrest and secure it with the Allen pin; apply the supplied rubber adhesive to the bottom of the bracket cover.