Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Ford
    3. :
  3. Fiesta
    4. : How to replace the front wheel bearing of the Ford Fiesta

Ford Fiesta - Video tutorial

Model: Ford Fiesta MK V, Fiesta 5, MK 5 - Years 2002-2008
Part: Bearing
Operation: How to replace the front wheel bearing of the Ford Fiesta

In this video tutorial we will see the steps that will allow us to disassemble and replace the front wheel bearing of the Ford Fiesta. First we lift the car and remove the front wheel; then we use a 17 mm socket wrench to disconnect the front axle shaft arm from the braking system, as shown in the video. At this point we unscrew the screws of the brake caliper, later also removing the brake disc; now we use a 32 mm socket wrench to unscrew the nut of the front bearing, replacing it with the new one!


Posted on 25 April 2024 by ScegliAuto



How to replace the front wheel bearing on Ford Fiesta?
Ford Fiesta (2008-2017 / MK VI, Fiesta 6, MK 6) The replacement of the Ford Fiesta front wheel bearing is carried out by lifting the car with a jack, so that the corresponding wheel is not in conta
How do you replace the front wheel bearing on a Ford Fiesta?
Ford Fiesta (2008-2017 / MK VI, Fiesta 6, MK 6) In order to replace the front wheel bearing on the Ford Fiesta, the car must be lifted so that the corresponding wheel does not touch the ground. The
How to replace the rear hub bearing on Ford Fiesta
Ford Fiesta (2002-2008 / MK V, Fiesta 5, MK 5) If it happens that while driving and especially when cornering you hear a noise coming from the rear wheel, then it is very likely that the hub beari

    Frequently Asked Questions

    • Fiesta 2008-2017 - How much is the front hub bearing of the Ford Fiesta 2009? Read Answer

Fiat Ducato 2.8 JTD gearbox oil replacement

Let's see in this guide the main steps to be able to change the transmission oil of the second series Fiat Ducato, with 2.8 JTD engine. First of all we lift the car and go to locate the gear oil vent bolt, which we find near the transmission; we use a hex wrench to unscrew it, letting it drain the old oil in a container for about ten minutes. At this point we open the bonnet and remove the air intake sleeve, so as to be able to access the gearbox oil filling hole; then we fill up to the maximum level!

Watch the video!


by ScegliAuto

More videos