Do it yourself
Frequently asked questions about cars and motorcycles

How to Change the Hazard Light Switch on a Ford Focus

Model: Ford Focus MK 3 - Years 2011-2018
Part: Checks and maintenance

To replace the hazard light switch on a Ford Focus, work from inside the dashboard by removing the radio from its housing. Use plastic trim tools to avoid damage. Disconnect the two main connectors to pull out the radio, and unscrew the four screws holding the dashboard in place. Carefully remove the dashboard to avoid damage; there are many electrical connectors attached, so take care when detaching them. Optionally, mark them to ensure correct reconnection later. Now that you have extracted the dashboard, unscrew the part where the emergency button is located. Two screws and it comes off. Install the new one (20.00 pounds on eBay), screw in the two screws, and reconnect all the connectors to their places. If marked correctly, you should have no difficulties. Refit the four screws and reconnect the two large radio connectors. Reinstall the radio and the job is done.

Updated on 13 June 2026 by ScegliAuto

Video tutorial

Related tutorials

Ford Focus (2011-2018 / MK 3) Today we will discover the instructions that will allow us to disassemble and replace the light switch of the Ford Focus. First, we open the front do…
Ford Focus (1998-2004 / MK 1) To replace the headlight switch on a Ford Focus, you need to loosen the screws securing the plastic panel under the steering column so that it can be…
Ford Focus (2011-2018 / MK 3) In this video tutorial, you will learn how to remove and replace the brake light switch on a third-generation Ford Focus by following these simple st…

    Frequently Asked Questions

    • Focus 2004-2011 - What problems encountered on the Ford 1.6 tdci 90 hp engine? Read answer
    • Focus 2004-2011 - Where is the outside temperature sensor of a Ford Focus located? Read answer
    • Focus 1998-2004 - Where is the immobilizer of a Ford Focus located? Read answer

How to Open a Stuck Boot on the Peugeot 407?

On the Peugeot 407, the boot may become stuck, possibly due to a problem with the control button or the lock actuator. In such cases, you can perform an emergency opening by following the simple procedure shown in this tutorial. First, open the rear doors, then lower the seat back by operating the release lever. Next, go inside the boot, locate the lock, and manually operate it using a flathead screwdriver. The boot will then be free to open.

Watch the video!


by ScegliAuto

More videos