Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Ford
    3. :
  3. Focus
    4. : How to disassemble the fuel pump of the Ford Focus

Ford Focus - Video tutorial

Model: Ford Focus MK 1 - Years 1998-2004
Part: Fuel pump
Operation: How to disassemble the fuel pump of the Ford Focus

Today's instructions will illustrate the main steps on how to disassemble and replace the fuel pump of the Ford Focus. In order to access the fuel pump, it will be necessary to disassemble the entire tank; so let's raise the vehicle and unscrew all the screws fixing the tank brackets, disconnecting the main fuel line and the electrical connector. At this point, unscrew the pump ring to remove it from the tank, replacing the float with the new original one; then finally reassemble the fuel tank, applying the reverse process!


Posted on 7 March 2024 by ScegliAuto

    Frequently Asked Questions

    • Focus 2011-2018 - How much does it cost to overhaul the Ford Focus diesel pump? Read Answer
    • Focus 2011-2018 - How much does it cost to replace the fuel pump on the Ford Focus 1.8 TDCi? Read Answer
    • Focus 2011-2018 - Where is the fuel pump of the Ford Focus 1.6 Tdci? Read Answer
    • Focus 2011-2018 - Where is the diesel pump located in the Ford Focus estate? Read Answer
    • Focus 2011-2018 - Where is the inertia switch on the Ford Focus 1.6? Read Answer
    • Focus 1998-2004 - Where is the 2000 Ford Focus fuel pump located? Read Answer
    • Focus 2011-2018 - Where is the fuel pump located in a diesel Ford Focus 1.8? Read Answer
    • Focus 2004-2011 - Where is the Ford Focus fuel pump located? Read Answer
    • Focus 2004-2011 - Where is the fuel float of the Ford Focus? Read Answer
    • Focus 2004-2011 - How much does the Ford Focus float cost? Read Answer

How to reset the TPMS light of the Volkswagen Polo 2011

The orange tire light indicates the presence of one or more tires with an inflation pressure below the recommended limit. All this is easily solved by inflating them correctly or replacing them in the event of a puncture. After carrying out these operations it is necessary to reset the warning light and therefore also the sensor in order to have new reading data. All you have to do is start the car ignition and then fully open the glove compartment on the passenger side. Locate the two buttons in the right corner and press "Set". At this point the reset is complete and you can turn off the ignition.

Watch the video!


by ScegliAuto

More videos