Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions

Model: Garelli Garelli

Today we will see the instructions on how to disassemble the thermal group of a Garelli 50cc, following these simple steps. In this case, the disassembly operation takes place with the engine disassembled, as the engine is cleaned and restored; to disassemble the thermal group we are going to unscrew the head screws, using a socket wrench. At this point we also remove the cylinder and end up removing the piston; to do this, remove the pin retainers with pliers and then remove the pin itself, using an extractor to avoid damaging the crankshaft connecting rod.


Posted on 6 January 2024 by ScegliAuto



Pneumatic disassembly and inner tube replacement on Garelli and Piaggio Si
Let's see in this video the simple instructions that will allow us to remove the tire from the rim and replace the inner tube on a Garelli 50cc, but
How to start the Garelli after so many years
In this guide we will see how to start the Garelli engine after many years of inactivity, following the instructions below. First of all, put the cen
How to overhaul the Garelli carburetor
In this video tutorial we will see the instructions that will allow us to overhaul the carburetor of the Garelli, as well as the Piaggio Si and Ciao.

How to change the motor oil of a KTM Duke 390?

To change the motor oil on a KTM Duke 390, start by placing the motorcycle on a stable stand to ensure it is in a vertical position. Under the engine, locate the oil drain plug and remove it with the appropriate wrench, allowing the used oil to completely drain into a suitable container. Once the oil has completely drained, screw the drain plug back on and tighten it properly. Next, locate the oil fill opening on the engine and fill it with the recommended new oil, using a funnel to prevent spills. Check the oil level to make sure it is correct, adding more oil if necessary. After completing the filling, start the engine and let it run for a few minutes to distribute the new oil. Finally, turn off the engine and check the oil level again, adding more if needed.

Watch the video!


by ScegliAuto

More videos