Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
In today's video, we will see the instructions that will allow us to remove and replace the clutch on a Garelli Super Sport. First, drain the engine oil from the bike by undoing the drain bolt located under the engine; then undo all the screws securing the clutch cover, which is on the left, as shown in the video. Next, undo the central nut of the clutch pack, inserting the piston lock into the spark plug hole to remove it and replace it with a new one; then apply the reverse procedure!

Updated on 12 April 2026 by ScegliAuto

Video tutorial

Related tutorials

How do you disassemble the engine of the Garelli Super Sport XL?
How do you disassemble the engine of the Garelli Super Sport XL?
Super Sport In order to disassemble the engine of the Garelli Super Sport XL, you need to loosen the screws that secure the block to its housing in the central p…
How do you replace the exhaust pipe of the Garelli Super Sport?
How do you replace the exhaust pipe of the Garelli Super Sport?
Super Sport In order to replace the exhaust pipe of the Garelli Super Sport, you need to loosen the screws that attach the exhaust pipe to the left side of the m…
How to Replace the Front Brake Shoes on a Garelli Super Sport XL
How to Replace the Front Brake Shoes on a Garelli Super Sport XL
Super Sport To replace the front brake shoes on the Garelli Super Sport, loosen the nuts that secure the central axle of the front wheel so that it can be remove…

How to Check the Coolant Level in a Yamaha Xmax

In the following video, you will learn how to check the coolant level in a 2008 Yamaha Xmax. First, position the motorcycle on a stable surface by raising the stand. Next, lift the cover located at the top of the motorcycle to access the coolant drain bolt. To top up the coolant, unscrew the cap as shown in the video and add the fluid until it reaches the maximum level, indicated as Max. Once finished, close the valve and refit the cover. At this point, start the engine and let it run at idle for a few minutes to eliminate any air bubbles that may have formed inside.

Watch the video!


by ScegliAuto

More videos