Do it yourself
Frequently asked questions about cars and motorcycles
In this guide we will see how to start the Garelli engine after many years of inactivity, following the instructions below. First of all, put the center stand and start by disassembling and replacing the spark plug, disconnecting the connector and using the appropriate key to unscrew it; then we go on to remove the bell cover to adjust the platinum points, as shown in the video. At this point, check that the carburetor is clean, refuel with fuel and start the engine using the pedals, following the video until the end!

Posted on 21 July 2024 by ScegliAuto

Video tutorial

Related tutorials

In this guide, we will provide instructions to remove and replace the carburettor on a Garelli 50. First, place it on the centre stand and start by d…
Today, you will see instructions on how to disassemble the engine unit of a Garelli 50cc, following these simple steps. The disassembly operation occ…
In this video tutorial, you will find the instructions that will allow you to overhaul the carburettor of the Garelli, as well as the Piaggio Si and …

How to Remove the Rear Wheel on the BMW G650 GS?

In this tutorial, you will see how to remove the rear wheel on the BMW G650 GS, a very simple operation. First, lift the motorcycle from the central area using a stand or a jack, then undo the right nut with a 24 mm socket and the left one with a 19 mm spanner. Once done, using a Torx T40 key, unscrew the two chain tensioner bolts exactly half a turn each, until you loosen the tension. Finally, push the wheel towards the inside of the motorcycle, remove the chain from the sprocket, and extract the inner pin using a hammer.

Watch the video!


by ScegliAuto

More videos