Do it yourself
Frequently asked questions about cars and motorcycles

Model: Gasgas Jtx 270
Part: Engine

To disassemble the GasGas JTX 270 engine, you need to loosen the screws that hold it to its housing, so that it can be completely freed from the frame: you also need to loosen the screws that hold the manifolds and remove the connectors of the appropriate sensors. Once the engine has been freed, you can loosen the cylinder fixing screws to remove it and detach the piston underneath from its connecting rod: at this point you can access the crankshaft and all the internal components that may need to be replaced.

Posted on 27 October 2024 by ScegliAuto

Video tutorial

Related tutorials

Jtx 270 To disassemble the GasGas JTX 270 engine, you need to loosen the screws that secure the block to its housing in the center of the frame: once the eng…
Jtx 270 In this guide, we will discover the instructions for changing the engine oil on the Gasgas JTX 270 enduro bike. First, place the bike on a stand and …
Jtx 270 In order to replace the rear fender of the GasGas JTX 270, you need to loosen the screws that secure the seat of the bike to its housing, so that it …

How to Service the Beta RR 350

This video will illustrate the steps to perform the routine maintenance service, replacing the engine oil and oil filter on the Beta RR 350 enduro bike. First, place the bike on a stand and start by loosening the oil drain bolt located under the engine, allowing it to drain into a container for about ten minutes; then clean the small oil filter (replacing it with a new one if too dirty). Finally, top up with new oil, of the correct type for your engine, filling to the maximum level!

Watch the video!


by ScegliAuto

More videos