Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How do you replace the motor oil of the GasGas SM 700?

Model: Gasgas Sm 700
Part: Engine oil

Video tutorial

The engine oil of the GasGas SM 700 can be replaced by loosening the screws that fix the engine guard plate located in the central lower part of the vehicle: once this plate has been removed, it will be possible to loosen the corresponding drain plug to completely drain the oil. Then it will be possible to remove the oil filter located in its housing and insert the new one, always in the same position; at this point it will be possible to proceed by topping up, pouring the necessary amount of oil from the vent on the left side of the vehicle, and then closing the cap.


Posted on 28 September 2025 by ScegliAuto


Related tutorials

How do you replace the engine oil of the GasGas SM 700?
How do you replace the engine oil of the GasGas SM 700?
Sm 700 It will be possible to replace the engine oil of the GasGas SM 700 by loosening the screws that secure the engine guard plate located in the central …
How do you replace the battery of the GasGas SM 700?
How do you replace the battery of the GasGas SM 700?
Sm 700 In order to replace the battery of the GasGas SM 700, you need to release the seat from its housing by pulling the lever located on the lower part of…
How do you replace the exhaust pipe of the GasGas SM 700?
How do you replace the exhaust pipe of the GasGas SM 700?
Sm 700 The replacement of the GasGas SM 700 exhaust can be carried out by unscrewing the screws that fix the seat to its housing: these screws will be locat…

Vespa Immobiliser: How to Transfer the Chip from the Old Key

In the case shown in the video, the new keys are not recognised by the ECU: the Vespa starts but does not run (thus the immobiliser is active). The solution shown in the video involves locating the immobiliser chip in the old key (the one recognised by the ECU). Open the cover on the key (only red master keys or some blue ones), remove the chip (which is a small black cylinder or rectangle), insert it into the new key in place of the new one, and try to start. Now the key will work. If the master key is red, it will definitely work. If it is blue, it might work: you need to cut the silicone; this is possible but a delicate operation. If it is a black clone key, then it is a system that does not work.

Watch the video!


by ScegliAuto

More videos