Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Model: Gasgas Ec300
Part: Light bulb

Remove the side panel and undo the single screw securing the seat. Take the seat off. Disconnect the fuel line and unscrew the three screws holding the tank (one on each side and one central, under the seat and beneath the sticker). It is advisable to clean the now visible parts of the bike by covering the filter and carburettor. Disconnect the original lighting system, noting that it has many more wires than the simplified version, although both are GasGas branded. If you wish, you can remove the ignition switch (on the left) and the kill switch (on the right) and install only the new ignition switch on the right (as most bikes have). Remember how the connectors of the original system were connected and do the same with the new simplified one.

Updated on 4 April 2026 by ScegliAuto

Video tutorial

Related tutorials

Replacing Rear Brake Pads on Gasgas EC300
Replacing Rear Brake Pads on Gasgas EC300
Ec300 Hello! Today, you will learn how to replace the rear brake pads on a Gasgas EC300. First, place the bike on a stand and remove the rear wheel by unsc…
How to Replace the Fork Bearings on a Gasgas EC300?
How to Replace the Fork Bearings on a Gasgas EC300?
Ec300 To replace the fork bearings on a Gasgas EC 300, first remove the front wheel by taking off the axle and securing bolts. Next, detach the brake calip…
Oil Change on Gasgas Ec300
Oil Change on Gasgas Ec300
Ec300 Warm the engine for several minutes to make the oil inside warmer and less viscous. This will aid the subsequent draining of the lubricant. For the s…

How to Replace the Clutch on a Triumph Speed Triple?

To replace the clutch on a Triumph Speed Triple, loosen the bolts securing the covers of the three casings located on the right side of the bike, namely the starter motor, the engine, and then the clutch. Once these covers are removed, you can access the bolts securing the clutch, unscrew them, and slide the clutch plates out of their housing. This will allow you to insert the new plates into their place, securing everything with the appropriate bolts; finally, reinstall all the casings.

Watch the video!


by ScegliAuto

More videos