Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Gasgas Ec300 - Video guides

Gasgas Ec300
Replacing the Coolant in a Gasgas Ec 300
In this brief guide, you will find the main instructions to help you bleed and top up the coolant in the Gasgas Ec 300 enduro bike. First, place your bike on a …Read all…
Posted on 12 July 2026 by ScegliAuto
Gasgas Ec300
How to replace the crankshaft oil seal on the Gasgas EC 300
Discover in this video how to disassemble and replace the crankshaft oil seal on the Gasgas EC 300 enduro bike, following the instructions below. First, remove …Read all…
Posted on 17 June 2026 by ScegliAuto
Gasgas Ec300
Replacing Rear Brake Pads on Gasgas EC300
Hello! Today, you will learn how to replace the rear brake pads on a Gasgas EC300. First, place the bike on a stand and remove the rear wheel by unscrewing the …Read all…
Posted on 15 June 2026 by ScegliAuto
Gasgas Ec300
How to Replace the Fork Bearings on a Gasgas EC300?
To replace the fork bearings on a Gasgas EC 300, first remove the front wheel by taking off the axle and securing bolts. Next, detach the brake caliper from …Read all…
Posted on 2 June 2026 by ScegliAuto
Gasgas Ec300
Replacing the Front Brake Pads on Gasgas EC300
Using a 5 mm Allen key, loosen the lower bolt of the brake caliper, then unscrew the two main bolts that secure it to the brake disc using a socket wrench. …Read all…
Posted on 19 May 2026 by ScegliAuto
Gasgas Ec300
How to Replace the Rear Brake Pads on a Gas Gas EC 300
Before you start, position your Gas Gas EC 300 vertically for easier access. Begin by unscrewing and removing the pins that secure the brake pads to the …Read all…
Posted on 19 May 2026 by ScegliAuto
Gasgas Ec300
Install Simplified Lighting System on GasGas EC300
Remove the side panel and undo the single screw securing the seat. Take the seat off. Disconnect the fuel line and unscrew the three screws holding the tank …Read all…
Posted on 6 May 2026 by ScegliAuto
Gasgas Ec300
Oil Change on Gasgas Ec300
Warm the engine for several minutes to make the oil inside warmer and less viscous. This will aid the subsequent draining of the lubricant. For the same …Read all…
Posted on 5 May 2026 by ScegliAuto

How to Reset the Tyre Pressure Light on the Opel Grandland X

While driving, if you notice the tyre pressure warning light coming on, first check the actual inflation pressure of the tyres and, if necessary, restore the pressures recommended by the manufacturer. After restoring the correct pressures, you need to reset the warning light that has illuminated on the instrument cluster. To do this, locate the reset button on the lower central console. Press this button and hold it down for at least 3 seconds, after which the low pressure indication will turn off.

Watch the video!


by ScegliAuto

More videos