|
Do it yourself
| |||
| ||||
Model: Gasgas Ec300
In this brief guide, you will find the main instructions to help you bleed and top up the coolant in the Gasgas Ec 300 enduro bike. First, place your bike on a stand and start by loosening the bleed screw located on the water pump casing, allowing the fluid to drain into a container. Next, remove the radiator filler cap to top up with the new antifreeze (of the correct type for your radiator). Pour in the coolant until you reach the maximum level!
Updated on 18 May 2026 by ScegliAuto
Video tutorial
Related tutorials
Ec300
Discover in this video how to disassemble and replace the crankshaft oil seal on the Gasgas EC 300 enduro bike, following the instructions below. Fir…
Ec300
To replace the fork bearings on a Gasgas EC 300, first remove the front wheel by taking off the axle and securing bolts. Next, detach the brake calip…
Ec300
Before you start, position your Gas Gas EC 300 vertically for easier access. Begin by unscrewing and removing the pins that secure the brake pads to …
|
How to replace the brake pads of the Ducati Monster 620?
To replace the brake pads of the Ducati Monster 620, loosen the screws that secure the brake calipers to their housing: these will be located on the sides of the calipers themselves. Once these are released, you can detach the caliper from the disc to remove the pads inside; after the old pads have been removed, insert the new ones into the caliper, securing them with the appropriate pin. After installing the pads, reattach the calipers to their position. by ScegliAuto More videos
|
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.006
(c) ScegliAuto 2026 - info@scegliauto.com - Privacy policy VAT number: IT01247470535 |
