Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to replace the knobs of the air conditioning controls of the Geely Lc

Model: Geely Lc MK 1 - Years 2008-2016
Part: Heater control valve

In today's video tutorial we will see, in simple and quick steps, how to disassemble and replace the knobs of the air conditioning controls of the Geely Lc, following the instructions below. First of all, we get on board the car and start removing the cocks from the air conditioning controls; to do this, pull them hard towards you, perhaps using pliers, as shown in the video. At this point we are going to fix the new air conditioning knobs, fitting them perfectly; Finally, let's check its operation, following the video tutorial until the end for reassembly!

Posted on 6 May 2022 by ScegliAuto

Video tutorial

Related tutorials

How to remove the door panel in the Geely LC?
How to remove the door panel in the Geely LC?
Geely Lc (2008-2016 / MK 1) In this tutorial we can see how to remove the door panel in the Geely LC, a very simple operation. First of all, unscrew the single screw of the inte…
Position and diagram of the fuses of the Geely LC.
Position and diagram of the fuses of the Geely LC.
Geely Lc (2008-2016 / MK 1) Let's see in this short and simple guide, the location and diagram of the fuses of the Geely LC, following the instructions below. First, we get into…
How to install Android car stereo on Geely Lc 1.0
How to install Android car stereo on Geely Lc 1.0
Geely Lc (2008-2016 / MK 1) In this video tutorial we will see the main instructions that will allow us to disassemble and replace the stock car stereo with an Android type of t…

How to Remove the CV Boot on Fiat Panda

Let’s see how to remove the boot from the joint on a Fiat Panda. After positioning your car on a column lift: raise it to a comfortable height to work on, loosen the wheel nuts (using a socket wrench or air drill) and remove the wheel. Begin unscrewing the brake disc bolts with a socket wrench. Remove the bolts located under the disc and completely detach the wheel hub. Pull the arm around the joint with your hands. Fit the new boot (after removing the old one) onto the constant velocity joint, then start reassembling all the parts in reverse order.

Watch the video!


by ScegliAuto

More videos