Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Wrap the Genesis GV80?

Model: Genesis Gv80 MK 1, JX1 - Years 2020-2026
Part: Accessory kit

Car wrapping is the process, perhaps still too little known, of changing the color of the body or interior of a vehicle by applying a special film. As can be seen in the video, the steps to perform car wrapping are few but require a considerable amount of time, especially in the final phase. First, clean the vehicle's body or the other parts where you want to do the car wrapping, then apply the film, shaping it according to the part where it will be applied. Once it is adhered, the difficult and lengthy part begins: use a card to remove all the air bubbles that are trapped. Finally, finish the edges and remove any excess film.

Updated on 1 June 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Remove the Door Panel in a Genesis GV80?
How to Remove the Door Panel in a Genesis GV80?
Genesis Gv80 (2020-2026 / MK 1, JX1) To remove the door panel in a Genesis GV80, unscrew the mounting screws located in the handle pocket and just behind the window switch panel. Once al…
How to Change the Engine Oil of the Genesis GV80?
How to Change the Engine Oil of the Genesis GV80?
Genesis Gv80 (2020-2026 / MK 1, JX1) To change the engine oil of the Genesis GV80, disconnect the fasteners securing the lower protective panel of the vehicle to access the oil drain plu…
How to Remove the Rear Headlight on the Genesis GV80?
How to Remove the Rear Headlight on the Genesis GV80?
Genesis Gv80 (2020-2026 / MK 1, JX1) To replace the rear headlight on the Genesis GV80, open the rear trunk of the vehicle to access the plastic cover next to the corresponding headlight…

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos