Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Check the Oil Level on a Gilera Nexus 500?

Model: Gilera Nexus 500
Part: Engine oil

Video tutorial

To check the engine oil level on the Gilera Nexus 500, locate the dipstick that allows monitoring. This is found on the right side of the bike, low down near the footpeg and above the exhaust.

Simply unscrew the cap to which the dipstick is attached to remove it from its housing. Once removed, it should be cleaned and reinserted into its housing, screwing it in completely.

If the fluid is between the minimum and maximum marks indicated by two notches, it means the oil level is sufficient. At the end of the operation, be sure to screw the cap back in completely.


Updated on 22 April 2026 by ScegliAuto


Related tutorials

How do you replace the front shock absorber of the Gilera Nexus 500?
How do you replace the front shock absorber of the Gilera Nexus 500?
Nexus 500 To replace the front shock absorber of the Gilera Nexus 500, you first need to remove the corresponding wheel by loosening the bolts that secure the …
How to Remove the Clutch Bell on a Gilera Nexus 500
How to Remove the Clutch Bell on a Gilera Nexus 500
Nexus 500 This guide outlines the steps necessary to remove and replace the clutch bell on the Gilera Nexus 500 scooter, following the instructions below. Firs…
How to Bleed the Brakes on a Gilera Nexus 500
How to Bleed the Brakes on a Gilera Nexus 500
Nexus 500 To bleed the brakes on a Gilera Nexus 500, open the compartment located near the knob by unscrewing the screws that secure the cover. Once opened, in…

Removing and Replacing the Battery of the Harley Davidson Iron 883

In this video, follow the instructions to remove and replace the battery of the Harley Davidson Iron 883. First, place your motorcycle on the stand and remove the rider's seat. Next, disconnect the electrical connector located on the side and undo the fixing screw of the battery bracket using a socket spanner with an extension, as shown in the video. At this point, disconnect the battery wiring to remove it and replace it with the new one, applying the reverse procedure!

Watch the video!


by ScegliAuto

More videos