Do it yourself
Frequently asked questions about cars and motorcycles

Model: Gilera Dna 125
Part: Engine oil

In this video tutorial, you will learn how to change the engine oil and oil filter on the Gilera Dna 125 - 50 by following these simple steps. First, start the engine and let it warm up for a few minutes; then, unscrew the oil drain bolt located under the engine, allowing it to drain into a container for about ten minutes. After that, screw the bolt back in, replacing its gasket, and open the filler cap to pour in the new engine oil with the correct specifications, filling it to the maximum level.

Updated on 25 April 2026 by ScegliAuto

Video tutorial

Related tutorials

Dna 125 Here are the steps to change the engine oil and oil filter while performing the routine maintenance service on the Gilera Dna 125 and 50. First, plac…
Dna 125 To remove the engine from a Gilera DNA 125, first disconnect it from its housing by unscrewing the bolts that secure it in place and disconnecting al…
Dna 125 To replace the spark plug on the Gilera DNA 125, disconnect the corresponding coil: these two parts will be located above the engine cylinder and acc…

How to Replace the Front Bulb on the Honda SH 125

This tutorial explains the steps to replace the front headlamp bulb on the Honda SH 125. This is a very simple procedure. First, remove the front shield of the scooter to access the bulb replacement. To perform this first step, unscrew the lower screw and the two upper screws that secure the cover. At this point, the bulb will be clearly visible. Simply unscrew the bulb and insert a new one. It is recommended to carry out this procedure after ensuring that the bulb to be removed has cooled down.

Watch the video!


by ScegliAuto

More videos