Do it yourself
Frequently asked questions about cars and motorcycles
To replace the transmission on a Gilera Runner 50, first loosen the screws securing the cover on the left side of the rear wheel. Once these screws are loosened, you can remove the cover to access the components underneath. Here, remove the nut that secures the central pin of the variator and the clutch, allowing you to take them out along with the drive belt. When all these components are removed, insert the new ones, securing them properly and closing the rear cover.

Updated on 18 May 2026 by ScegliAuto

Video tutorial

Related tutorials

Runner 50 This guide outlines the steps to remove and replace the drive belt of the Gilera Runner 50 scooter. First, place the scooter on the centre stand and …
Runner 50 To replace the transmission on the Gilera Runner 50, loosen the screws that secure the cover on the left side of the rear wheel: once these screws ar…
Runner 50 This guide provides instructions on how to change the transmission oil of the Gilera Runner 50 two-stroke scooter. First, place your scooter on the c…

How to Top Up the Oil in the Aprilia SR 50 R Scooter?

In this tutorial, you will see how to top up the oil in the Aprilia SR 50 R scooter, a very simple and quick operation to perform periodically. First, open the small lower compartment and retrieve the supplied tools, then remove the screws securing the front panel located at the back. Once removed, locate the oil reservoir, which is on your left, and unscrew the cap. At this point, proceed to top up the oil until you reach the optimal level, then reassemble everything by following the reverse procedure.

Watch the video!


by ScegliAuto

More videos