Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Motorcycles
    2. :
  2. Gilera
    3. :
  3. Dna 50
    4. : How do you dismantle the engine of the Gilera DNA 50?

Model: Gilera Dna 50
Part: Engine
How do you dismantle the engine of the Gilera DNA 50?

The disassembly procedure of the Gilera DNA 50 engine involves removing the engine from its housing by unscrewing the fixing screws and disconnecting all the cables related to its sensors: at this point it will be possible to proceed by loosening the screws that fix the cylinder to the top of the engine block, removing the spark plug and the specific coil. At this point, the underlying piston can be detached from its connecting rod and then it will be possible to access the additional internal components; then all the new replacement parts can be inserted and the engine can be reassembled in its seat.


Posted on 18 May 2024 by ScegliAuto



How do you dismantle the engine of the Gilera DNA 50?
Dna 50 The procedure for disassembling the engine of the Gilera DNA 50 is carried out by loosening the screws that fix it to the respective supports, so tha
How to replace the spark plug of a Gilera DNA 50?
Dna 50 Good morning, today we will be replacing the spark plug on our Gilera DNA 50. Let's start by carefully removing the side fairings of the motorcycle.
How do you replace the stator of the Gilera DNA 50?
Dna 50 In order to replace the stator of the Gilera DNA 50, you need to loosen the screws that fix the engine block to its supports: once this has been remo

How to change the Royal Enfield Himalayan engine oil and filter

The guide shows you how to change the Royal Enfield Himalayan engine oil and oil filter. The first operation to perform is to secure the vehicle and turn it on to make the oil fluid. At this point, after having placed protection against splashes under the bleed valve and having prepared a container for the disposal of used oil, with a 22 mm wrench, open the valve. Using an 8 mm wrench, remove the fixing bolts of the inspection hatch of the mesh filter and extract the latter. Refit the clean filter and close the door; install the gasket on the purge valve and tighten it in place. On the opposite side of the vehicle, unscrew the three 8 mm bolts and drain the oil from the filter. Remove the old cartridge and clean the housing. Pour some oil into the new cartridge to facilitate the circulation of the oil. Put everything back in place. Fill the tank to the correct level and run the engine for a few minutes. Check the level again and top up if necessary.

Watch the video!


by ScegliAuto

More videos