Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to replace the rear suspensions of the Harley Davidson Sportster Iron 883

Model: Harley Davidson Sportster Iron 883
Part: Suspension system

Video tutorial

These short and simple instructions will show us how to disassemble and replace the rear suspensions of the Harley Davidson Sportster Iron 883 motorcycle. First of all, we put the motorcycle on the stand and start unscrewing and removing the suspension bolts that we find at the top and bottom; on this motorcycle there are two suspensions where we will need to proceed in the same identical way for disassembly, as shown in the video.

At this point, we install the new rear suspension, of the right type, finally adjusting the preload with the appropriate key (if possible).


Posted on 9 February 2025 by ScegliAuto


Related tutorials

How do you replace the rear shock absorber of the Harley Davidson Sportster Iron 883?
How do you replace the rear shock absorber of the Harley Davidson Sportster Iron 883?
Sportster Iron 883 To replace the rear shock absorber of the Harley Davidson Sportster Iron 883, you need to loosen the screws that secure the component to its housing,…
How do you replace the spark plugs on the Harley Davidson Sportster Iron 883?
How do you replace the spark plugs on the Harley Davidson Sportster Iron 883?
Sportster Iron 883 To replace the spark plugs of the Harley Davidson Sportster Iron 883, you will need to disconnect the coils that are connected to the top of the engi…
How to Replace the Rear Brake Pads on a Harley Davidson Sportster Iron 883?
How to Replace the Rear Brake Pads on a Harley Davidson Sportster Iron 883?
Sportster Iron 883 To replace the rear brake pads on the Harley Davidson Sportster Iron 883, loosen the screws securing the rear brake caliper, located immediately next…

How to Change the Gear Oil on a Vespa 125 LX?

To change the gear oil on a Vespa 125 LX, unscrew the drain plug of the reservoir that contains the oil: this is located at the lower rear of the transmission casing, on the left side of the bike near the rear wheel. Once the drain plug is removed, collect the oil in a container until it is empty. At this point, top up through the breather located at the rear of the bike by adding the necessary amount of oil and then close the plug.

Watch the video!


by ScegliAuto

More videos