Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
In this video tutorial, learn how to dismantle the exhaust end of a Harley Davidson Sportster Iron in simple steps. First, ensure the engine is cold to avoid burns; then undo the two screws of the end can located at the bottom and loosen the nut that holds the end can using a 19 mm spanner: now remove the heat shield from the rear end can. At this point, perform the same operation for the other end can to remove them, as shown in the video; apply the reverse procedure for reassembly!

Updated on 23 April 2026 by ScegliAuto

Video tutorial

Related tutorials

How to replace the rear suspensions of the Harley Davidson Sportster Iron 883
How to replace the rear suspensions of the Harley Davidson Sportster Iron 883
Sportster Iron 883 These short and simple instructions will show us how to disassemble and replace the rear suspensions of the Harley Davidson Sportster Iron 883 motorc…
How to Replace the Brake Fluid on Harley Davidson Sportster Iron
How to Replace the Brake Fluid on Harley Davidson Sportster Iron
Sportster Iron 883 In today's video, you will learn how to bleed the braking system and replace the brake fluid on a Harley Davidson Sportster Iron, as well as on most …
How to Replace the Rear Brake Pads on a Harley Davidson Sportster Iron 883?
How to Replace the Rear Brake Pads on a Harley Davidson Sportster Iron 883?
Sportster Iron 883 To replace the rear brake pads on the Harley Davidson Sportster Iron 883, loosen the screws securing the rear brake caliper, located immediately next…

How to Replace the Battery in a Yamaha FZ6?

Replacing the battery in the Yamaha FZ6, as shown in this tutorial, is a very simple and quick operation. First, ensure that the key is not inserted, then remove the rider's seat and, using a 10mm socket spanner, loosen the bolt on the tank hinge. Next, unscrew both the front bolts and the fairing mounting bolts, lift the entire tank, and disconnect both terminals starting with the negative. At this point, you can remove the upper plastic plate, take the battery out of its housing, and fit the replacement.

Watch the video!


by ScegliAuto

More videos