|
Do it yourself
| |||
| ||||
|
Model: Harley Davidson Sportster
Follow these steps to remove and replace the starter motor of the Harley Davidson Sportster. First, place your bike on a stand and begin by removing the left side cover of the transmission to access the clutch and starter motor. Then, unscrew the fixing screws of the starter motor, disconnecting the power electrical connector to remove it, as shown in the video. At this point, install the new original starter motor to ensure proper functioning, finally reassembling the transmission cover!
Updated on 17 June 2026 by ScegliAuto
Video tutorial
Related tutorials
Sportster
In this tutorial, you can see how to replace the front headlight on the Harley-Davidson Sportster, an extremely simple and quick operation. Before pr…
Sportster
In this tutorial, you will see how to replace the front headlamp on a Harley-Davidson Sportster, an extremely simple and quick operation. First, ensu…
Sportster
This guide will show you the steps to remove and replace the battery of the Harley Davidson Sportster motorcycle, following the instructions below. F…
|
How to Service the Beta RR 350
This video will illustrate the steps to perform the routine maintenance service, replacing the engine oil and oil filter on the Beta RR 350 enduro bike. First, place the bike on a stand and start by loosening the oil drain bolt located under the engine, allowing it to drain into a container for about ten minutes; then clean the small oil filter (replacing it with a new one if too dirty). Finally, top up with new oil, of the correct type for your engine, filling to the maximum level! by ScegliAuto More videos
|
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.005
(c) ScegliAuto 2026 - info@scegliauto.com - Privacy policy VAT number: IT01247470535 |
