Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Model: Harley Davidson Dyna
Part:

To replace the levers on a Harley Davidson Dyna, loosen the nut located at the base of the cable connected to the corresponding lever. Once this is loosened, you can unscrew the pin that secures the lever to the end of the handlebar, allowing it to be removed from its housing and subsequently disconnected from the cable. This way, you can connect the new lever to the corresponding cable, inserting it into its housing and securing it with the pin. Finally, tighten the nut at the base of the cable again.

Updated on 22 June 2026 by ScegliAuto

Video tutorial

Related tutorials

How do you replace the levers on the Harley Davidson Dyna?
How do you replace the levers on the Harley Davidson Dyna?
Dyna In order to replace the levers of the Harley Davidson Dyna, you need to loosen the nuts that secure them to the respective housing on the right and l…
How to Replace the Front Brake Pads on a Harley Davidson Dyna?
How to Replace the Front Brake Pads on a Harley Davidson Dyna?
Dyna You can replace the front brake pads on a Harley Davidson Dyna by loosening the screws that secure the brake caliper to its housing, near the front b…
How do you replace the front brake pads on the Harley Davidson Dyna?
Dyna To replace the front brake pads of the Harley Davidson Dyna, you will need to loosen the screws that secure the brake caliper to the corresponding di…

How to Check the Coolant Level in a Yamaha Xmax

In the following video, you will learn how to check the coolant level in a 2008 Yamaha Xmax. First, position the motorcycle on a stable surface by raising the stand. Next, lift the cover located at the top of the motorcycle to access the coolant drain bolt. To top up the coolant, unscrew the cap as shown in the video and add the fluid until it reaches the maximum level, indicated as Max. Once finished, close the valve and refit the cover. At this point, start the engine and let it run at idle for a few minutes to eliminate any air bubbles that may have formed inside.

Watch the video!


by ScegliAuto

More videos