Do it yourself
Frequently asked questions about cars and motorcycles
In this guide, we will cover the instructions on how to remove and replace the starter motor on a Harley Davidson Dyna motorcycle. First, place the bike on a stand and start removing the left cover or casing to access the chain and clutch. You will also find the starter motor, where you will need to unscrew its fixing screws to remove it, as shown in the video. Now, install the new original starter motor, replacing the clutch cover gasket and reinstalling the casing, following the video tutorial until the end!

Updated on 24 July 2026 by ScegliAuto

Video tutorial

Related tutorials

Dyna Below are the steps to remove and replace the starter motor on a Harley Davidson Dyna motorcycle. First, place your motorcycle on a stand and begin b…
Dyna Below are the instructions for removing and replacing the battery on a Harley Davidson Dyna motorcycle. First, place the bike on a stand and start by…
Dyna Below are the main steps to disassemble and replace the battery of the Harley Davidson Dyna motorcycle. First, place your motorcycle on a stand and s…

How to Service the Piaggio Vespa GTS 300

This brief guide will illustrate the main steps to perform the routine maintenance service on the Piaggio Vespa GTS 300, replacing the engine oil and oil filter. First, place the scooter on the centre stand and start by unscrewing the oil drain bolt found under the engine, allowing it to drain into a container for about ten minutes; then unscrew the oil filter cartridge using the appropriate tool, and hand-tighten the new one. Finally, unscrew the filler cap and top up, filling to the maximum level mark!

Watch the video!


by ScegliAuto

More videos