Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
This guide provides instructions for removing and replacing the front wheel of the Harley Davidson Dyna motorcycle, following these simple steps. First, place your motorcycle on a stand and begin to unscrew the bolts securing the front brake caliper to remove it from the disc; then unscrew the central axle bolt of the front wheel, removing it from its axle, as shown in the video. At this point, if necessary, replace the tyre with a new one, reassemble the wheel, and securely fasten the front brake caliper (checking the wear condition of the pads)!

Updated on 7 August 2026 by ScegliAuto

Video tutorial

Related tutorials

How do you replace the clutch of the Harley Davidson Dyna?
How do you replace the clutch of the Harley Davidson Dyna?
Dyna It will be possible to replace the clutch of the Harley Davidson Dyna by loosening the transmission cover located on the lower right side of the moto…
How do you replace the battery of the Harley Davidson Dyna?
How do you replace the battery of the Harley Davidson Dyna?
Dyna To replace the battery of the Harley Davidson Dyna, you need to loosen the screws that secure the panel located immediately under the seat: this pane…
How to replace the engine mount of the Harley Davidson Dyna.
How to replace the engine mount of the Harley Davidson Dyna.
Dyna The following steps will guide us through the process of disassembling and replacing the rear engine mount of the Harley Davidson Dyna. First, we pla…

How to Check the Coolant Level in a Yamaha Xmax

In the following video, you will learn how to check the coolant level in a 2008 Yamaha Xmax. First, position the motorcycle on a stable surface by raising the stand. Next, lift the cover located at the top of the motorcycle to access the coolant drain bolt. To top up the coolant, unscrew the cap as shown in the video and add the fluid until it reaches the maximum level, indicated as Max. Once finished, close the valve and refit the cover. At this point, start the engine and let it run at idle for a few minutes to eliminate any air bubbles that may have formed inside.

Watch the video!


by ScegliAuto

More videos