Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Motorcycles
    2. :
  2. Harley Davidson
    3. :
  3. Dyna
    4. : How do you replace the air filter on the Harley Davidson Dyna?

Model: Harley Davidson Dyna
Part: Air filter
How do you replace the air filter on the Harley Davidson Dyna?

The procedure for replacing the air filter on the Harley Davidson Dyna involves loosening the screws that secure the cover located on the right side of the motorcycle, just below the fuel tank. Once the cover has been removed, the underlying filter can be located: it must be removed from its seat by loosening the fixing screws and pulling it out from inside its housing. After the old filter has been removed, the new replacement piece can be installed, securing it in place with the screws and reinstalling the removed cover.


Posted on 19 May 2024 by ScegliAuto



How do you replace the Harley Davidson Dyna air filter?
Dyna In order to replace the Harley Davidson Dyna air filter, you need to loosen the screws that secure the casing located on the right side of the bike,
How to replace the engine oil and oil filter of the Harley Davidson Dyna.
Dyna Following this procedure, we will see how to perform the routine maintenance service, by replacing the engine oil and oil filter, of the Harley David
How do i replace the Harley Davidson Dyna battery?
Dyna The battery replacement of the Harley Davidson Dyna is carried out by loosening the bolts that secure the protective casing of the battery, located o

How to change the engine oil and the relative filter of the Ducati 999

The guide shows how to change the Ducati 999 engine oil. If you have racing stands, you can use them too. Start the motorcycle to make the oil fluid and remove the right fairing by removing the fixing points and the fixing bolts. Place a container under the oil pan to dispose of the fluid and unscrew the drain bolt; also unscrew the oil filler cap. Unscrew the four screws of the mesh filter and empty it; pay attention to the cap gasket. Detach the mesh filter from its housing, taking care not to break it; clean it well before reassembling it. Unscrew the oil filter and drain the fluid. Put the filters back in place, after having greased the gaskets and refilling the tank. Run the engine for a few minutes and then top up the oil level.

Watch the video!


by ScegliAuto

More videos