Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions

Honda Cb500x - Videoguide

Honda Cb500x
How to replace the air filter in the Honda CB500X?
Replacing the air filter in the Honda CB500X, as we can see in this tutorial, is a very simple and fast operation. First of all remove the saddle, then loosen …read all…
Posted on 20 April 2023 by ScegliAuto
Honda Cb500x
How to do engine oil change on Honda CB500X
This guide shows how to change the engine oil on the Honda CB500X. After having made the vehicle safe, unscrew the drain bolt with a 12 mm wrench, located on …read all…
Posted on 18 December 2022 by ScegliAuto
Honda Cb500x
How to replace the headlight bulb on a Honda CB500X
Before starting, we will have to place our Honda CB500X on the side stand. Let's start by releasing the clips that secure the rear bulb cover, located below …read all…
Posted on 18 April 2024 by ScegliAuto
Honda Cb500x
Wheel replacement on Honda CB500X
Today we will show you how to change the wheels on Honda CB500X. Let's start with the front wheel: lift the bike with a special stand. Remove the brake caliper …read all…
Posted on 8 March 2024 by ScegliAuto
Honda Cb500x
Replacement brake pads on Honda Cb500x
Unscrew the lower bolt that holds the brake caliper tight: doing this should already fall off the old brake pads but if this does not happen, slightly spread …read all…
Posted on 17 January 2024 by ScegliAuto
Air filter (1) Headlight bulb (1) Engine oil (1) Brake pads (1) Wheel (1)

How to reset the tire pressure warning light on Dacia Sandero?

Let's see below how it is possible to reset the low tire pressure signal on the car: first of all it is necessary to check the correct tire pressure by comparing it with the pressures reported in the use and maintenance manual. After that, turn on the ignition and locate the command on the right side of the steering wheel at the top that allows you to access the on-board computer menu, then select the car symbol, after which select the "up arrow" command up to that the indication "tire pressure" appears on the display. At that point, press the "Ok" control on the steering wheel and keep it pressed to reset the signal.

Watch the video!


by ScegliAuto

More videos