Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Model: Honda Cb500x
Part: Wheel

Today, you will learn how to change the wheels on a Honda CB500X. Start with the front wheel: lift the bike using a suitable stand. Remove the brake caliper by unscrewing the two bolts. Loosen the right tightening bolt, then unscrew the counterpart and remove the central axle of the bike. While you are at it, clean the rim thoroughly and grease the working parts of it. Reassemble the wheel by proceeding in reverse order. Tighten the central axle using the bolts with a torque wrench set to 51 Nm. Repeat the procedure on the rear wheel, but be careful to remove the belt without damaging it.

Updated on 26 April 2026 by ScegliAuto

This video is currently unavailable

Related tutorials

How to replace the headlight bulb on the Honda CB500X?
How to replace the headlight bulb on the Honda CB500X?
Cb500x In this tutorial, we will see how to replace the headlight bulb on the Honda CB500X, an extremely simple and quick operation. First of all, let's mak…
How to replace the motor oil in the Honda CB500X?
How to replace the motor oil in the Honda CB500X?
Cb500x In this tutorial we can see how to replace the motor oil in the Honda CB500X, an extremely simple and fast operation. First of all, make sure that th…
How to Replace the Front Headlight Bulb on a Honda CB500X?
How to Replace the Front Headlight Bulb on a Honda CB500X?
Cb500x Before you begin, position your Honda CB500X on the side stand. Start by unfastening the clips that secure the rear cover of the bulb, located beneat…

How to Turn Off the "V-Belt" Warning Light on a Yamaha X-MAX 400 Scooter?

In this tutorial, learn how to turn off the "V-Belt" warning light on the Yamaha X-MAX scooter's instrument panel, a very simple and quick operation. Before doing this, ensure you have completed the required maintenance, specifically replacing the drive belt. Start by inserting the key and turning on the ignition, then open the small right glove compartment and unscrew the screw for the upper cover. Once removed, locate the white connector with a jumper attached, disconnect it, wait about 10 seconds, and reconnect it. If successful, the warning light will disappear.

Watch the video!


by ScegliAuto

More videos