Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Honda
    3. :
  3. Cr Z
    4. : Accessory kit

Honda Cr Z - Accessory kit

Accessory Kit Honda Cr Z (2010-2016 / mk 1)

Honda Cr Z (2010-2016 / MK 1)
How to Install Illuminated Scuff Plates
This tutorial illustrates step by step how to install the "CRZ" illuminated finish on the scuff plate of each door. First, obtain the kit in question. Remove …Read all…
Posted on 15 February 2026 by ScegliAuto
Honda Cr Z (2010-2016 / MK 1)
Installing Wheel Splash Guards
This video shows how to install splash guards on all four wheels. To install them on the front wheels, you need to find the right position and make a hole …Read all…
Posted on 14 February 2026 by ScegliAuto
Honda Cr Z (2010-2016 / MK 1)
Replacing Rubber Floor Mats
This video shows how to replace rubber floor mats. Once the old rubber mats are removed, replace them with new ones specifically designed to fit the car's …Read all…
Posted on 14 February 2026 by ScegliAuto
Honda Cr Z (2010-2016 / MK 1)
Fitting the Rubber Mat in the Boot
To protect the boot floor and ensure the load adheres to the boot, it may be useful to insert a specifically shaped rubber mat: this operation is quite simple …Read all…
Posted on 13 February 2026 by ScegliAuto
Honda Cr Z (2010-2016 / MK 1)
Installation of Additional Armrest
Ensure you have the anti-theft code for the car radio. Disconnect the negative cable from the battery. Remove the lower centre of the tunnel. Insert your hand …Read all…
Posted on 9 February 2026 by ScegliAuto
Cabin air filter (1) Accessory kit (5) Handle (1) Engine oil (1) Brake pads (1) Shift knob (1) Fuse box (1) Service warning light (5)

How to Connect the Cables to the Battery of the Citroen Xsara Picasso?

In this tutorial, you will see how to connect the cables to the battery of the Citroen Xsara Picasso, useful if you need to recharge it or perform an emergency start. First, ensure the key is not inserted, then open the bonnet and move to the front of the left headlamp. Next, locate the bolt just behind the filter box and connect the positive terminal clamp to it. Now you can connect the negative terminal to any point on the chassis, such as the indicated point. Once the operation is complete, ensure you disconnect the negative first and then the positive.

Watch the video!


by ScegliAuto

More videos