Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Fitting the Rubber Mat in the Boot

Model: Honda Cr Z MK 1 - Years 2010-2016
Part: Accessory kit

To protect the boot floor and ensure the load adheres to the boot, it may be useful to insert a specifically shaped rubber mat: this operation is quite simple and does not require special knowledge or skills. Insert it in the correct orientation inside the rear compartment, checking if the side flaps need to be removed due to the presence of speakers: if necessary, simply cut them off with scissors. At this point, the mat can be perfectly repositioned in the car's boot.

Updated on 8 February 2026 by ScegliAuto

Video tutorial

Related tutorials

Replacing Rubber Floor Mats
Replacing Rubber Floor Mats
Honda Cr Z (2010-2016 / MK 1) This video shows how to replace rubber floor mats. Once the old rubber mats are removed, replace them with new ones specifically designed to fit the …
How to Install Illuminated Scuff Plates
How to Install Illuminated Scuff Plates
Honda Cr Z (2010-2016 / MK 1) This tutorial illustrates step by step how to install the "CRZ" illuminated finish on the scuff plate of each door. First, obtain the kit in question…

How to Replace the Battery on a Honda Vision 110

To replace the battery on a Honda Vision 110, you need to remove the front fairing of the motorcycle, located directly under the front headlamp. To loosen this panel, unscrew the two screws found at its top, just below the handlebar. Once these screws are loosened, lever under the panel to detach it, gaining access to the battery underneath: this battery must be removed from its housing by unscrewing the fixing screws and disconnecting the power cables, replacing it with a new one.

Watch the video!


by ScegliAuto

More videos