Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to change the engine oil of a Honda Click 125i?

Model: Honda Click 125
Part: Engine oil

Video tutorial

To change the engine oil of a Honda Click 125i, first ensure the bike is on a flat surface and that the engine has been warmed up for a few minutes, as warm oil drains better. Turn off the engine and place a container under the engine to collect the used oil. You will find the oil drain plug at the bottom of the engine; remove it with a spanner and allow the old oil to drain completely.

Once all the oil has drained, clean the plug and the drain hole before refitting the plug, ensuring it is tight. Next, fill the engine with new oil, using a funnel to avoid spills.

Gradually add oil until you reach the correct level, being careful not to overfill. After adding the oil, start the engine for a few minutes to allow the new oil to circulate.

Turn off the engine and check for any leaks around the drain plug.


Updated on 23 October 2026 by ScegliAuto


Related tutorials

How to Change the Engine Oil of the Honda Click 125i?
How to Change the Engine Oil of the Honda Click 125i?
Click 125 The engine oil of the Honda Click 125i can be replaced by removing the drain plug located at the central lower part of the bike, corresponding to the…
How to change the engine oil in the Honda Click 125 scooter?
How to change the engine oil in the Honda Click 125 scooter?
Click 125 In this tutorial, you will see how to change the engine oil in the Honda Click 125 scooter, a very simple and quick operation. First, ensure that the…
How to Change the Engine Oil of a Honda Click 125?
Click 125 To change the engine oil of a Honda Click 125, start by warming up the engine for a few minutes to make the oil more fluid for effective drainage. Tu…

How to Replace the Clutch on a Kymco Downtown 125?

To replace the clutch on the Kymco Downtown 125, loosen the screws that secure the cover located on the left side of the bike, near the rear wheel. Once the screws are loosened, remove the cover to access the components underneath: the clutch at the rear can be removed by unscrewing the fixing screws and sliding out all the discs that make it up. At this point, insert the new replacement part, reposition the drive belt, and cover everything with the cover.

Watch the video!


by ScegliAuto

More videos