How to Change the Engine Oil of a Honda Click 125?

Model: Honda Click 125
Part: Engine oil

This video is currently unavailable

To change the engine oil of a Honda Click 125, start by warming up the engine for a few minutes to make the oil more fluid for effective drainage. Turn off the engine and place the bike on a centre stand for stability.

Under the engine, locate the oil drain plug. Position a collection tray under the plug and use a spanner to unscrew it, allowing the used oil to drain completely.

Once the oil has fully drained, clean the drain plug and the hole, then refit the drain plug and tighten it securely. Next, locate the oil filler cap, usually found on top of the engine.

Remove it and use a funnel to slowly pour in the recommended quantity and type of new oil as specified in the owner's manual. Once the oil level is correct, replace the filler cap and ensure it is tightly secured.

Start the engine for a few minutes, then turn it off and check the oil level, adding more if necessary.

Updated on 2 October 2026 by ScegliAuto

How to Replace the Rear Brake Pads on a Benelli TRK 502X?

To replace the rear brake pads on a Benelli TRK 502X, loosen the screws that secure the corresponding caliper so that it can be detached from the brake disc: once the caliper is removed from its disc, you can proceed to detach it and remove the pin that secures the pads inside the caliper. At this point, you can remove the old pads from their seat to insert the new ones: these must be secured properly by positioning the caliper and checking that the brake is functioning.

Watch the video!

by ScegliAuto

How to Change the Engine Oil of a Honda Click 125?

Related tutorials

How to Replace the Rear Brake Pads on a Benelli TRK 502X?

More videos