Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
To change the oil in a Honda Transalp motorcycle, first prepare the bike in a well-ventilated and flat area, using a center stand to ensure a stable position. Make sure you have a container to collect the used oil and a suitable wrench for the drain plug. Lift the bike and position the container under the engine to collect the oil that will come out. Remove the drain plug located at the bottom of the engine and let it drain completely. This process may take a few minutes for all the oil to be completely removed. Once the oil is fully drained, reinsert and tighten the drain plug, making sure it is well sealed to avoid leaks. Proceed to pour the new oil through the filling opening, which is usually located on the top of the engine. Use the specific oil for your Transalp, following the manufacturer's instructions. After filling the engine, start the bike and let it run for a few minutes to allow the oil to circulate and distribute evenly. Finally, turn off the engine and check for any leaks, making sure the oil level is correct. Dispose of the used oil according to environmental regulations and regularly check the oil level to ensure optimal engine lubrication.

Posted on 18 July 2025 by ScegliAuto

Video tutorial

Related tutorials

How to change the engine oil of a Honda Transalp?
How to change the engine oil of a Honda Transalp?
Transalp Xl600v To change the motor oil of a Honda Transalp, start by placing the motorcycle on a flat and secure surface, preferably on a center stand. Slightly war…
How to disassemble the front headlight on a Honda Transalp XL600V
How to disassemble the front headlight on a Honda Transalp XL600V
Transalp Xl600v To remove the front headlight and replace the bulb on a Honda Transalp Xl600v, follow these steps. Remove the windshield and mirrors: unscrew the hex…
Fork Oil Change on Honda Transalp XL600V
Fork Oil Change on Honda Transalp XL600V
Transalp Xl600v Loosen the two 12 mm bolts on the shaft and the 17 mm bolt located just above. Raise the bike with a jack (place something soft on the jack to avoid …

How to Replace the Front Brake Pads on a Peugeot Elyseo 125

This guide briefly explains how to remove and replace the front brake pads on the Peugeot Elyseo 125 scooter. First, place your scooter on the centre stand and start unscrewing the bolts securing the front brake caliper to remove it from the disc; then, apply pressure to the caliper piston and clean it from any residual dirt, as shown in the video. At this point, remove and replace the brake pads with new, high-quality ones, installing them in the correct orientation and then refitting the brake caliper!

Watch the video!


by ScegliAuto

More videos