Do it yourself
Frequently asked questions about cars and motorcycles

How to change the engine oil on a Honda Transalp?

Model: Honda Transalp Xl600v
Part: Engine oil

Video tutorial

To change the engine oil on a Honda Transalp, start by placing the bike on a flat and secure surface, preferably on a centre stand. Slightly warm the engine to make the oil more fluid and facilitate drainage.

Under the engine, locate the oil drain plug situated at the bottom of the sump and remove it with a suitable spanner, allowing the used oil to drain into an appropriate container. Once the oil has completely drained, replace the drain plug, ensuring it is tightly secured.

At this point, locate the oil filler cap, usually found on top of the engine. Remove the cap and pour in the new engine oil through the opening, using a funnel to avoid spills.

Regularly check the oil level to ensure it is adequate, adding oil if necessary. Finally, restart the engine and let it run for a few minutes to allow the oil to circulate, then switch off and check the level again.

If everything is in order, replace the filler cap and the engine oil has been successfully changed.


Updated on 16 October 2026 by ScegliAuto


Related tutorials

Transalp Xl600v To change the oil in a Honda Transalp motorcycle, first prepare the bike in a well-ventilated and flat area, using a center stand to ensure a stable …
Transalp Xl600v To remove the front headlamp and replace its bulb on the Honda Transalp XL600V, follow these steps. Remove the windscreen and mirrors by unscrewing t…
Transalp Xl600v Loosen the two 12 mm bolts on the shaft and the 17 mm bolt located just above. Raise the bike with a jack (place something soft on the jack to avoid …
ScegliAuto offers an extensive international collection of automotive tutorials available in 12 languages. Each guide combines instructional videos with original explanations written by experienced human editors, along with information about the car models covered.

How to Replace the Battery on a Yamaha Zuma 125?

To replace the battery on a Yamaha Zuma 125, first disconnect the cover located in the centre of the footwell, just behind the steering column. Once the cover is removed, you will find the battery underneath, which needs to be freed from its housing by unscrewing the fixing screws and disconnecting the power cables. After the device is released, insert the new one into its housing, connecting the appropriate power cables and securing it properly.

Watch the video!


by ScegliAuto

More videos