Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Model: Honda Transalp Xl600v
Part:

Loosen the two 12 mm bolts on the shaft and the 17 mm bolt located just above. Raise the bike with a jack (place something soft on the jack to avoid damaging the bike) and unscrew the bolt that acts as a plug for the drain hole of the left front fork. Collect the used oil in a container and move to the right side of the bike, repeating the same procedure. For optimal results, I recommend an additional step: remove the springs from the handlebar area and raise the front wheel on a spacer of about 14 inches to fully compress the fork, which will release more oil. Fill with new oil from the top hole, as shown in the video.

Updated on 4 April 2026 by ScegliAuto

Video tutorial

Related tutorials

How to disassemble the front headlight on a Honda Transalp XL600V
How to disassemble the front headlight on a Honda Transalp XL600V
Transalp Xl600v To remove the front headlight and replace the bulb on a Honda Transalp Xl600v, follow these steps. Remove the windshield and mirrors: unscrew the hex…
How to change the engine oil of a Honda Transalp?
How to change the engine oil of a Honda Transalp?
Transalp Xl600v To change the motor oil of a Honda Transalp, start by placing the motorcycle on a flat and secure surface, preferably on a center stand. Slightly war…
How to change the motor oil of a Honda Transalp?
How to change the motor oil of a Honda Transalp?
Transalp Xl600v To change the oil in a Honda Transalp motorcycle, first prepare the bike in a well-ventilated and flat area, using a center stand to ensure a stable …

How to Turn Off the "V-Belt" Warning Light on a Yamaha X-MAX 400 Scooter?

In this tutorial, learn how to turn off the "V-Belt" warning light on the Yamaha X-MAX scooter's instrument panel, a very simple and quick operation. Before doing this, ensure you have completed the required maintenance, specifically replacing the drive belt. Start by inserting the key and turning on the ignition, then open the small right glove compartment and unscrew the screw for the upper cover. Once removed, locate the white connector with a jumper attached, disconnect it, wait about 10 seconds, and reconnect it. If successful, the warning light will disappear.

Watch the video!


by ScegliAuto

More videos