Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Model: Honda Pcx 160
Part: Wheel

Today we will see the instructions that will allow us to disassemble and replace the rear wheel or tire on the Honda PCX 160 scooter. First, we put the scooter on the center stand and start disassembling and removing the muffler, unscrewing the fixing screws and disconnecting it from the exhaust manifold; then we unscrew the screws of the arm, also disconnecting it from the suspension, as shown in the video. At this point, we unscrew the central nut of the wheel to remove it, replacing the tire if necessary; all that's left is to reassemble everything!

Posted on 15 November 2025 by ScegliAuto

Video tutorial

Related tutorials

How to replace the battery of the Honda PCX 160
How to replace the battery of the Honda PCX 160
Pcx 160 The instructions in this guide will show us how to disassemble and replace the battery of the Honda PCX 160 scooter. First, we put the scooter on the…
How to reset the service on the Honda PCX 160 scooter?
How to reset the service on the Honda PCX 160 scooter?
Pcx 160 In this tutorial we can see how to reset the service on the Honda PCX 160 scooter, an extremely simple and quick operation, to be carried out only on…
How to adjust the time on the Honda PCX 160 scooter?
How to adjust the time on the Honda PCX 160 scooter?
Pcx 160 In this tutorial we can see how to adjust the time on the Honda PCX 160 scooter, an extremely simple and quick operation, to be carried out for examp…

How to Check the Coolant Level in a Yamaha Xmax

In the following video, you will learn how to check the coolant level in a 2008 Yamaha Xmax. First, position the motorcycle on a stable surface by raising the stand. Next, lift the cover located at the top of the motorcycle to access the coolant drain bolt. To top up the coolant, unscrew the cap as shown in the video and add the fluid until it reaches the maximum level, indicated as Max. Once finished, close the valve and refit the cover. At this point, start the engine and let it run at idle for a few minutes to eliminate any air bubbles that may have formed inside.

Watch the video!


by ScegliAuto

More videos