Engine Oil and Oil Filter Replacement Honda CBR 600 RR

This guide describes how to replace the engine oil and oil filter on a Honda CBR600RR. Obtain 3 litres of Motul 7100 SAE 10W40 oil and a Champion COF104 oil filter. Position the motorcycle on the rear stand.

Start the engine, allow it to reach operating temperature, and then switch off. Place a container for collecting the used oil under the engine. Using a 4mm Allen key, unscrew the screws on the lower front fairing (chin) and detach the two parts from the frame.

Using a ratchet and a 12mm socket, unscrew the oil drain plug located under the rear of the engine. Allow the oil to drain and clean the plug thoroughly.

Use a 65mm socket to unscrew the oil filter located at the front of the engine. Lubricate the seal of the new filter with oil, screw it in by hand, and then tighten it a turn with the socket.

Screw in the oil drain plug. Clean any oil-soiled exhaust headers with brake cleaner.

Open the oil filler cap located on the right side of the engine casing. Pour in the oil, referring to the inspection hole at the bottom of the casing.

Start the engine for a minute and switch off. Check the oil level again.