Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
In this tutorial, you will learn how to reset the dual-clutch transmission (DCT) on a Honda X-ADV. This procedure should be performed in case of malfunction or if you wish to restore factory settings. First, start the engine and set the gearbox to position N, then turn it off and turn it back on while holding the D button, releasing it only once the engine light goes off. At this point, follow the sequence DDNDN, restart the engine, and let it idle for a few seconds. If the procedure has been carried out correctly, the D and S lights will disappear.

Updated on 16 August 2026 by ScegliAuto

Video tutorial

Related tutorials

How to reset the DCT gearbox in the Honda X-ADV 750 scooter?
How to reset the DCT gearbox in the Honda X-ADV 750 scooter?
X Adv In this tutorial, we can see how to reset the DCT gearbox on the Honda X-ADV 750 scooter, an extremely simple and quick operation to be carried out, …
Replacement of the battery of the key remote control of the Honda X Adv.
Replacement of the battery of the key remote control of the Honda X Adv.
X Adv The following step-by-step instructions will show us how to disassemble and replace the battery of the key remote for the Honda X Adv motorcycle. Fir…
How do you replace the exhaust pipe of the Honda X-ADV?
How do you replace the exhaust pipe of the Honda X-ADV?
X Adv To replace the exhaust pipe installed on the Honda X-ADV, you need to loosen the screws that hold the exhaust terminal to its housing, located on the…

How to Turn Off the "V-Belt" Warning Light on a Yamaha X-MAX 400 Scooter?

In this tutorial, learn how to turn off the "V-Belt" warning light on the Yamaha X-MAX scooter's instrument panel, a very simple and quick operation. Before doing this, ensure you have completed the required maintenance, specifically replacing the drive belt. Start by inserting the key and turning on the ignition, then open the small right glove compartment and unscrew the screw for the upper cover. Once removed, locate the white connector with a jumper attached, disconnect it, wait about 10 seconds, and reconnect it. If successful, the warning light will disappear.

Watch the video!


by ScegliAuto

More videos