Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Application of Tinted Films

Model: Honda CR-V MK 3 - Years 2007-2012
Part: Side window

For the application of tinted films on the windows, specific equipment is required: glass cleaner and a sponge with a mesh for cleaning, application liquid, a specific cutter, a heat gun, and a set of squeegees.
Keep in mind that the film will need to be shaped and moulded from the outside and then applied from the inside: to shape it, place the film externally on the glass with the release liner always facing outwards.
Once the glass has been carefully cleaned, wet it with the appropriate application liquid and place the film externally on the glass (with the release liner always facing outwards), shape it appropriately, and mould it with a squeegee and heat gun to avoid air bubbles and give it the correct curvature.
At this point, wet the glass internally, remove the outer liner from the film, and stick it to the glass from the inside: then use the squeegee to adhere it, eliminating all excess water.

Updated on 3 February 2026 by ScegliAuto

Video tutorial

Related tutorials

Fitting Rubber Mats
Fitting Rubber Mats
Honda CR-V (2002-2007 / MK 2) Using rubber mats over the original carpet mats is an absolutely smart solution; this way, you preserve the original mats from dirt and wear, and pre…
Installing Deflectors on Door Windows
Installing Deflectors on Door Windows
Honda CR-V (2012-2017 / MK 4) To install deflectors on the car doors, first fully lower the windows. Then, using a spatula, carefully pry out the seal in the areas where the brack…
Application of Wood Effect Interior Finishes
Application of Wood Effect Interior Finishes
Honda CR-V (2007-2012 / MK 3) You can apply adhesive plates to enhance the aesthetics of the dashboard and the internal trims of the door panels with a wood effect or aluminium fi…

How to Open the Bonnet of a Renault Megane if the Lever is Broken?

If the lever that unlocks the bonnet of the Renault Megane is broken or not functioning, there is an emergency procedure to unlock the mechanism: remove the right front grille located at the top of the bumper. Once the grille is removed, you can locate the actuator mechanism: by pulling the spring in this position, you can unlock the actuator, allowing you to lift the bonnet and access the components located inside the engine compartment. You can then close the bonnet simply by lowering it.

Watch the video!


by ScegliAuto

More videos