Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Honda
    3. :
  3. City
    4. : How to remove the Honda City instrument cluster

Honda City - Video tutorial

Model: Honda City GM8, GM6, GM5, GM4, MK 6, GM9 - Years 2014-2023
Part: Instrument cluster
Operation: How to remove the Honda City instrument cluster

In this short and simple guide we will see the steps on how to disassemble and replace the Honda City instrument cluster, following the instructions below. First of all we get on board the car and start removing the plastic bulkhead that we find on the upper part of the instrument panel; after which we unscrew the fixing screws that we find below, using a Phillips screwdriver, as shown in the video. At this point we unscrew the additional screws that we find on the sides of the panel, slightly removing the central unit; then disassemble the instrument panel, disconnecting the electrical connectors on the back!


Posted on 13 September 2022 by ScegliAuto

    Frequently Asked Questions

    • Honda City 2008-2021 - What to do if the Honda City EPS light comes on? Read Answer
    • Honda City 2008-2021 - What to do if the Honda City 5 engine light comes on? Read Answer
    • Honda City 2014-2023 - What problems does the Honda City have with the fuel gauge? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos