Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Piston on the Husqvarna TE 250

Model: Husqvarna Te 250

Video tutorial

This guide outlines the steps to disassemble and replace the piston of the engine assembly on the Husqvarna TE 250 enduro bike. First, place the bike on a stand and begin by removing the seat and side panels, then take off the fuel tank.

Next, remove the exhaust and disconnect the cooling circuit from the engine assembly, as shown in the video. At this point, unscrew the head bolts and then slide off the cylinder.

Remove the pin from the piston by taking off the clips, then replace it with the new one, following the video to the end!


Updated on 24 June 2026 by ScegliAuto


Related tutorials

How to Dismantle the Front Wheel and Brakes of the Husqvarna TE 250
How to Dismantle the Front Wheel and Brakes of the Husqvarna TE 250
Te 250 Today's instructions will show you how to dismantle and replace the front brakes and wheel of the Husqvarna TE 250 enduro bike. First, place the bike…
How do you disassemble the engine of the Husqvarna TE 250?
How do you disassemble the engine of the Husqvarna TE 250?
Te 250 To disassemble the engine of the Husqvarna TE 250, you need to loosen the bolts that secure the engine block to its housing, located in the lower cen…
Replacing the Air Filter on a Husqvarna TE 250
Replacing the Air Filter on a Husqvarna TE 250
Te 250 In today's tutorial video, we will see how to remove and replace the air filter on a Husqvarna TE 250 in a few simple steps. First, remove the plasti…

How to Change the Engine Oil of a Royal Enfield Meteor 350

To change the engine oil of a Royal Enfield Meteor 350, park the bike on a flat surface and ensure the engine is off and cold. Locate the oil drain plug under the engine and position a container to collect the used oil. Use a suitable spanner to unscrew the drain plug and allow the oil to fully drain. Once finished, replace the plug's gasket if necessary and screw it back in tightly. Remove the oil filter and replace it with a new one, lightly lubricating the gasket before fitting it. Fill the engine with the oil specified in the manual, using a funnel to avoid spills. Check the oil level using the dipstick or inspection window. Finally, start the engine for a few minutes, turn it off, and recheck the level, topping up if necessary.

Watch the video!


by ScegliAuto

More videos