Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
The following instructions will show you how to perform the routine maintenance oil change on the Husqvarna FE 350 enduro motorcycle. First, place the bike on a stand and start unscrewing the oil drain bolt located under the engine, allowing it to drain into a container for about ten minutes; then unscrew the screws of the oil filter cover, located on the left side of the engine block, and replace the small cartridge with a new one, as shown in the video. At this point, unscrew the filler cap and pour in the engine oil, finally starting the engine!

Updated on 15 September 2026 by ScegliAuto

Video tutorial

Related tutorials

How to replace the engine oil and oil filter of the Husqvarna FE 350.
How to replace the engine oil and oil filter of the Husqvarna FE 350.
Fe 350 In this guide, we will see the instructions on how to perform the routine maintenance service by replacing the engine oil and oil filter of the Husqv…
How to Change the Engine Oil and Oil Filter on the Husqvarna FE 350
How to Change the Engine Oil and Oil Filter on the Husqvarna FE 350
Fe 350 Today we will discover the steps to perform routine maintenance by replacing the engine oil and oil filter on the Husqvarna FE 350 enduro bike. First…
Changing the Engine Oil and Oil Filter on the Husqvarna FE 350
Changing the Engine Oil and Oil Filter on the Husqvarna FE 350
Fe 350 In this short and simple guide, discover how to perform routine maintenance by changing the engine oil and oil filter on the Husqvarna FE 350 enduro …

How to Replace the Air Filter on a Harley Davidson Dyna?

To replace the air filter on a Harley Davidson Dyna, loosen the screws securing the cover located on the right side of the bike, just below the fuel tank. Once the cover is removed, you will locate the filter underneath: it must be removed from its housing by unscrewing the fastening screws and sliding it out from its compartment. After the old filter has been removed, position the new replacement part, securing it in place with the screws and covering everything with the cover.

Watch the video!


by ScegliAuto

More videos