Do it yourself
| ||||
|
Jeep Cherokee - Video tutorial
Model: Jeep Cherokee
MK 5, KL
- Years 2013-2023 If you notice a strange warning light on your on-board computer that warns you of a problem with tire pressures, don't worry because it's nothing serious. Everything is resolved by following the next instructions. In fact, it is a signal that warns us of the detection of a tire pressure that is too low or in any case below the optimal level. Therefore, to remove the warning light, it is necessary to inflate the tires to the right pressure and carry out a few kilometers of test so as to allow the sensor to detect and memorize the new values in the control unit. As soon as all of this is completed, the light will permanently disappear from the display.
Posted on 28 March 2024 by ScegliAuto
How to reset the tire pressure light on Jeep Cherokee 2
Jeep Cherokee (2002-2007 / MK 3, KJ) Today we will see how to reset the tire pressure warning light on a 2006 Jeep Cherokee, second series; before carrying out the operation it is necess
How do you reset the tire pressure warning light on the Jeep Cherokee?
Jeep Cherokee (2013-2023 / MK 5, KL) In order to reset the tire pressure warning light on the Jeep Cherokee, you must first bring the tires back to the correct inflation pressure: this v
How to reset the tire pressure sensor on the Jeep Cherokee
Jeep Cherokee (2013-2023 / MK 5, KL) In this short and simple guide, we will see how to reset and restore the tire pressure light on the Jeep Grand Cherokee. First of all, get into the c Other guides that may interest you
|
Frequently Asked QuestionsHow to reset the oil service in the Fiat Toro?In this tutorial we can see how to reset the oil service in the Fiat Toro. Before carrying out this simple and quick operation, make sure that you have completed any required maintenance work. We start by inserting the key but leaving it in the initial position, after which we keep the accelerator pedal fully depressed and at the same time turn on the instrument panel. At this point, always keeping the accelerator pressed, press the brake pedal 5 consecutive times and, with the pedals in position, turn off the ignition. We check that the procedure has been successful by starting the vehicle. by ScegliAuto More videos
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.064
(c) ScegliAuto 2024 - info@scegliauto.com - Privacy Policy VAT number: IT01247470535 |